Mounting Reflectors; Installing Wheel Guards; Attaching Wheels - Burley Honey Bee Owner's Instruction And Safety Manual

Mounting Reflectors

1. Screw reflectors and brackets together.
2. Loosen screws on reflector brackets. Mount reflectors/
brackets horizontally on rear corners of side frame tubes,
with reflectors extending out past trailer sides.
3. Tighten screws securely.
WARNING
MAKE SURE REFLECTORS FACE OUTWARD. INCORRECTLY
INSTALLED REFLECTORS CAN REDUCE VISIBILITY AND CAUSE AN
ACCIDENT OR SERIOUS INJURY.

Installing Wheel Guards

1. Match holes in wheel guards with holes on outside of lower
side frame tubes.
2. From inside the frame, insert wheel guard screws through
frame tube and wheel guards. Tighten securely.

Attaching Wheels

1. Insert wheel axle assembly completely into trailer
axle.
FIGURE 4
2. Close quick release lever, with lever aimed at trailer rear.
A properly adjusted quick release lever should leave an
imprint on your palm when the lever is rotated to the closed
position.
FIGURE 5
3. Verify that tires are inflated to pressure marked on tire
side wall.
4. To remove wheel from trailer axle, open quick release lever.
WARNING
MAKE SURE WHEELS ARE HELD SECURELY, WITH WHEEL AXLE
ASSEMBLY FULLY INSERTED INTO TRAILER AXLE. YOU SHOULD
NOT BE ABLE TO ROCK OR SHIFT WHEELS. IMPROPERLY
INSTALLED WHEELS CAN FALL OFF, CAUSING AN ACCIDENT OR
SERIOUS INJURY.
PHOTO 2
FIGURE 3
Bracket
Reflector
PHOTO 2:
Trailer left rear corner
Screws
FIGURE 3:
Wheel guard installation
Top View
FIGURE 4:
Quick release lever in unlocked
"open" position
B U R L E Y H O N E Y B E E O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
Left Side
Frame Tube
Wheel Guard
Lower Side
Frame Tube
Trailer
Rear
Top View
FIGURE 5:
Quick release lever in locked
"closed" position
5