Attaching The Seat; Mounting Reflectors; Installing Wheel Guards - Burley Bee Owner's Instruction And Safety Manual

Attaching the Seat

Attach hooks on seat sides to D-rings by windows. Always keep
these attached while trailering.

Mounting Reflectors

1. Snap posts on red reflectors (C) into bracket openings, and
screw together.
2. Loosen screws on reflector brackets. Slide bracket
clamps (A) onto rear side sections of main frame tube (B)
and tighten screws, with reflectors extending out past trailer
sides. Figure 3
A
B
C
Figure 3
Mounts
horizontally
to frame
IMPORTANT:
MAkE SURE REFLECTORS FACE OUTWARD. INCORRECTLY INSTALLED REFLECTORS CAN
REDUCE VISIBILITY AND CASE AN ACCIDENT OR SERIOUS INjURY.

Installing Wheel Guards

Match holes in wheel guards with holes on outside of lower side
frames. Install guards using (2) M6 x 35mm screws inserted
from inside the frame. Tighten securely. Figure 4
Figure 4
Wheel Guard
B U R L E Y C H I L D T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
|