HP Kayak XU 04xx Administration Manual page 18

Host SCSI ID
Scan Order
Removable Media
Support
CHS Mapping
NOTE
In general it is not advisable to change your host adapter ID from the
default value of 7, as this gives it the highest priority on the SCSI bus.
However, if you have two adapters sharing the same SCSI devices, you
should give one of the adapters a currently-unassigned ID to avoid
duplication of SCSI IDs.
This option lets you tell the host adapter BIOS and your device drivers
to scan the SCSI bus from low to high (0 to max) SCSI ID, or from high
to low (max to 0) SCSI ID. If you have more than one device on a SCSI
bus, changing the device order changes the drive letters which are
assigned to them by the system. This will change the boot order.
Only used when removable disk drives are installed. For more
information, refer to the User's Guide that came with you removable
disk drive.
This option defines the cylinder head sector (CHS) values that are
mapped onto an un-partitioned disk.
is the default setting.
For full compatibility with other SCSI adapters CHS mapping should be
set to
Alternate CHS Mapping
The
SCSI Plug and Play Mapping
options will not work if the hard disk has been partitioned using
To remove partitioning reformat your hard disk using either the
option or the
Format Disk
To complete the reformat, you will need to restart your PC
Workstation.
SCSI Plug and Play Mapping
.
and
Alternate CHS Mapping
command at a DOS prompt.
FDISK /MBR
Configuring the SCSI Bus
.
FDISK
English 13