Preparing To Remove The System Board - HP Kayak XU 04xx User Manual

Preparing to Remove the System Board

Due to the fact that the Intel Pentium II Xeon processor weighs about 1 kg,
the system board can be damaged because of vibration if it is not securely
set in place.
The system board on the Kayak XU Series 0441 PC Workstation is secured to
the PC chassis by seven screws. These screws are longer than the standard
ones used on the PC Workstation and are not available as spare parts. If you
do lose or mislay any of these screws, there are four spare ones located on
the front of the chassis (underneath the audio front panel). These screws
are to be used uniquely to secure the system board.
Before attempting to remove the system board, you will have to first
unscrew these screws. Six of them can be accessed from the outside of the
chassis, while the seventh screw is located near PCI Slot 3.
Screw located near PCI Slot 3
that needs to be removed before
removing the system board.
Preparing to Remove the System Board
PCI 1
PCI 2
PCI 3
RAID
PORT
PCI 4
11