Troubleshooting The Integrated Ata Raid Configuration Utility - HP DL320 - ProLiant - G3 Setup And Installation Manual

RAID Configuration and Management
•
To restart the utility, perform one of the following actions:
— Log out of and back into Windows to restart the utility.
— Reboot the unit.
— Manually start the application.
Novell Operating Systems
•
From the console, type
that the module has been unloaded.
•
To start the utility again, simply type
respond with a message verifying this operation.
Linux Operating Systems
•
From a prompt, type
•
To restart the utility, type
Troubleshooting the Integrated ATA RAID
Configuration Utility
•
Inconsistent naming may occur between the Power-On Self-Test (POST) and the
Integrated ATA RAID Configuration Utility. Such is the case when a drive has
failed in a RAID 1 or RAID 1+0 configuration. The POST message will list the
array as running in a
Configuration Utility will list it as being in a
inconsistency occurs, the array must be rebuilt.
•
If drives are added to a configuration, the Integrated ATA RAID Management
Utility tray icon (which is seen only under Microsoft operating systems) may
indicate yellow or red, depending on the array condition. The color change
indicates one of the following situations:
— Errors are present on the array.
6-8
. The system should respond with a message
Unload Spy
Load Spy
.
Spy-Stop
.
Spy-Start
state and the Integrated ATA RAID
Degraded
HP ProLiant DL320 Generation 2 Server Setup and Installation Guide
. Once again, the system should
state. If this
Rebuilding