Canon LBP-1000 Service Manual page 175

Message
not enough memory to support the setup.
CONTEXT SAVE The user has pressed Go key to go on-line
CHANGE after adjusting the context saving feature.
The printer is allocating enough memory for
the context saving feature.
LOAD <SIZE> Load the specified tray with the correct
IN <TRAY> paper size, according to the message.
<paper source>
CASSETTE1: The internal cassette
CASSETTE2: The optional paper feeder
MPT: The Multi-purpose tray
ANY TRAY: Any tray that support Letter-,
Legal-, A4-, A5-, Executive-, or B5-JIS-size
paper.
<size>
LETTER: Letter size paper
LEGAL: Legal size paper
A4: A4 size paper
A5: A5 size paper
EXEC: Executive size paper
COM10: Commercial #10 envelope
MONARCH: Monarch envelope
DL: DL envelope
C5: C5 envelope
B5-JIS: B5-JIS size paper
B5-ISO: B5-ISO envelope
CUSTOM: Paper loaded from the MPT or
manual feed
Any: Unknown paper size
LOAD <size> Load Multi-purpose tray with the specified
IN MANUAL paper.
MEM ALLOC There is not enough memory available to
ERROR process the data and print the page.
AUTOCONT is ON (CONFIG MENU), the
print job will resume after 10 seconds.
RESTORING This message is displayed when the RESET
DEFAULTS =MENU is selected in the RESET MENU.
MRT COMPRES- The printer is using MRT Compression, with
SION the possibility of print quality deration (lossy
compression)
TONER CART No toner cartridge is installed in the printer,
MISSING or the cartridge is not installed correctly.
OPERATION CHECK This is the Control Panel Diagnostic Mode.
PANEL CHECK Displays during a panel check function.
PANEL CHECK Displays when panel check function is com-
DONE plete
PAGES: #### This message is displayed when SHOW
PAGE COUNT is selected in the TEST
Meaning
If
APPENDEX
Action
Press Go key to enable the new
setting and resume operation.
The specified paper source must
be loaded with the requested
paper size. To continue the print
job, you may have to press Go
key.
If the paper source runs out of
paper during printing, reloading
the paper source will allow the
printer to continue printing.
For manual feed, you need to
press Go key to continue printing.
Press the Go key to resume print-
ing.
If AUTOCONT is OFF, you must
press the Go key to resume print-
ing. Check the printed page to
ensure that it is complete.
No action required.
No action required.
Replace the toner cartridge or, if
cartridge is installed, remove it
and insert it again.
For detail, see Chapter 2.
No action required.
A - 13