Table of Contents
Advertisement
6) Lift up the fixing film unit to remove.
Fixing film unit
Figure 3-4-14
Note:
When replacing the fixing film unit,
do not touch the fixing film.
Be sure not to damage the AC cable
with the edge of the metal plate.
J. Pressure Roller
1) Remove the fixing unit according to the
steps 1) through 3) on page 3-9.
2) Remove the fixing film unit.
3) Remove the gear.
4) Remove the screw holding the fixing
entrance guide.
5) While lifting the claw of the fixing
entrance guide, slide the guide to
remove.
6) Lift up the pressure roller to remove.
Gear
Screw
Fixing entrance guide
Pressure roller
Figure 3-4-15
Note:
When lifting up the pressure roller,
be sure not to deform the plate
spring on the side without gear.
CHAPTER 3
3 - 15
Advertisement
Chapters
Table of Contents
Troubleshooting
