C. Intermediate Pcb - Canon LBP-1000 Service Manual

cially flat cable) securely.
< Check after reassembly >
After reassembly, make a test print to con-
firm that there is no image defects (white
vertical lines) on the printed image.

C. Intermediate PCB

1) Remove the drive unit according to the
steps 1) through 3) on page 3-7.
2) Disconnect the 3 connectors.
Connectors
Figure 3-8-5
3) Remove the screw, disconnect the con-
nector, and then remove the intermedi-
ate PCB.
Screw Intermediate PCB
Figure 3-8-6
< Note for reassembly >
When installing the intermediate PCB, be
sure to install the flat cable securely.
CHAPTER 3
3 - 25