Table of Contents
Advertisement
CHAPTER 3
D. Video Controller PCB
1) Remove the options such as RAM,
DIMM, or ROM, if installed.
2) Remove the top cover unit and right
cover.
3) Remove the 3 screws, and then the
memory cover.
Screws
Memory cover
Figure 3-8-7
4) Disconnect the 2 connectors, remove
the 5 screws, and then the video con-
troller unit.
Connectors
Screws
Video controller PCB
Figure 3-8-8
3 - 26
5) Remove the 4 screws, and then the
video controller unit mounting plate.
Screws
Video controller unit mounting plate
Figure 3-8-9
6) Remove the 3 screws. Move the video
controller PCB to the direction of the
arrow to remove the connector and then
the video controller PCB.
Screws
Video controller PCB
Figure 3-8-10
< Note for reassembly >
When installing the video controller unit,
be sure to set the flat cable securely.
If there are options removed, be sure to
reinstall them to where they came from.
Advertisement
Chapters
Table of Contents
Troubleshooting
