Add Snmp Trapreceiver; Add Sshkey - HP BL480c - ProLiant - 4 GB RAM User Manual

•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
A maximum of two DNS servers can be added.
o
The <ip address> must be in the form ####:####:####:####:####:####:####:#### or
o
####:####:####:####:####:####:####:####/### (with a prefix), where each ####
ranges from 0 to FFFF and the prefix /### ranges from 0 to 128.

ADD SNMP TRAPRECEIVER

•
Command:
ADD SNMP TRAPRECEIVER <host> ["<community name>"]
•
Description:
Adds a new trap receiver address to the SNMP configuration. Defaults for the traps are version v1
and port 162. The SNMP Trap community string is set to public or the optional "<community
name>". The "<community name>" string, if specified, must be 1 to 20 characters in length.
Acceptable characters include any printable character excluding quotes and newlines.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
A maximum of eight IP addresses can be added to receive SNMP traps.
o
Only v1 traps are supported.
o
The <host> value can be an IPv4 address, an IPv6 address, or a DNS name (maximum of 64
o
characters).
IPv6 addresses must be typed without the network prefix length.
o

ADD SSHKEY

•
Command:
ADD SSHKEY <end marker> <certificate> <end marker>
•
Description:
Adds an SSH key or keys to the Administrator local account. Multiple SSHKEYs can be concatenated
in the string.
Locate a string that does not appear in the key, to use as the end marker.
a.
Paste in the SSHKEY string.
b.
Finish the command with the end marker.
c.
Failure to give a proper end marker before and after the certificate might cause the interface to wait
for the appropriate end marker indefinitely.
•
Access level/Bay level:
Administrator
•
Restrictions:
Enclosure network configuration commands 80