Brady Tagus User Manual page 55

PRINTHEAD CLEANING
CLEAN HEAD SCHEDULE
000 in. (* 1000)
CLEAN HEAD COUNTER
0 in.
RESET COUNTER
CLEAN HEAD NOW
The Menu System
Controls the printhead cleaning routine.
Specifies the inch (or centimeter) count to reach
before prompting a printhead cleaning. If the
number specified is exceeded three times, the
printer will fault until cleaning is initiated.
Notes: The default value (zero) disables this function.
Also, the number specified is multiplied by one thousand.
Indicates the number of inches (or centimeters)
since printhead cleaning was last initiated.
Allows the clean head counter to be set to zero
Initiates printhead cleaning and resets the Clean
Head Counter.
Notes:
•
Remove ribbon, if installed.
•
Enter Menu Mode / Media Settings / Media Type and
set the printer for Direct Thermal.
•
Ensure that full width media is installed.
•
See Section 6.1 for detailed instructions.
5-9 Rev A