Brady Tagus User Manual page 122

Displayed Message
TOP OF FORM FAULT
7-8 Rev A
Printer Fault Messages
Description
The printer could not find the
TOF mark within the
maximum label length setting
or it found a TOF in an
unexpected place.
Note: When the printer
is set for reflective media,
this fault is given for an out
of stock condition.
Fault and Warning Messages (Display Printers Only)
Possible Solution(s)
If media is moving:
1. Press the FEED Key. It may be
necessary to re-calibrate the
printer; see Section 5.4.
2.
The Media Sensor may be out of
position. Readjust it; see Section
3.3.
3.
The media may not be properly
loaded. Reload media, also ensure
that the Media Guide is positioned
properly; see Section 3.2.
4.
The Leveling Cam may be
improperly adjusted; see Section
6.2.
5.
The label may be longer than the
default value for maximum length.
Check the Media Settings /
Maximum Label Length; see
Section 5.1.2.
6.
The Media Sensor may be
obstructed. Check and carefully
remove any obstruction (labels, paper
dust, adhesive, etc).
If media is not moving:
The printhead assembly may not be
latched; close it.