66-Block Labels - Brady IDXPERT User Manual

Terminal Block display screen examples:
Display screen before text/zones
entered

66-Block Labels

Note: See DataComm & T-Block Menu Selections for a list of the high-level DataComm
& T-Block Menu selections, their default values, and the corresponding softkeys.
This example outlines the functionality required to create a 66-Block label using the DataComm &
T-Block menu. This example also assumes the use of a dedicated 66-Block label part (width = .375").
To create a 66-Block label:
Step 1. Insert a dedicated part (XC-375-498). The printer reads the smart-cell settings and
automatically displays the screen allowing you to choose between the General ID Menu
and DataComm & T-Block Menu. Upon selecting the DataComm & T-Block Menu, the
following datacomm menu options appear above the softkeys:
P-PNL, T-BLK, DESI, 110BLK, 66BLK, BIX.
Note: To escape to the General ID Menu screen press
Step 2. Press , then the
NEXT
appears on the display screen as shown below (in inches or millimeters, depending on user
settings*):
Step 3. To set or accept the length, do one of the following:
• Press the
ENTER
• Press the
LEN
Note: From this point, similar functionality is used as when working with Patch Panels.
See Patch Panel Labels on page 23 for more information.
26
Display screen showing 12-zone label
with the first of 12 zones displayed
softkey. The default 66-Block information automatically
66-BLK
*See Setting Units on page 36 for instruction on setting
units to inches or millimeters.
key to accept the default, or
softkey, enter a new width, and press
+
FUNCTION CLEAR/ESC
.
ENTER
User Manual
.