Fonts - Brady IDXPERT User Manual

Fonts

Fonts are available in these point sizes: 4 pt., 6 pt., 7 pt., 9 pt., 10 pt., 13 pt., 16 pt., 20 pt., 26 pt.,
32 pt., 38 pt., 42pt., 45pt., 51pt., 55pt., 60pt., 65pt., 70pt., 76 pt., 102 pt., and AUTO. Symbols
and numbers can also be printed in these font sizes. The IDXPERT
a 126 pt. (1.25", 31.75mm) font for uppercase characters only.
Note: Refer to Appendix C—Font Size Chart on page 52 to view available font sizes.
Default Font Size
When a cartridge is loaded and the unit is turned on, the IDXPERT
label size information stored in the smart cell. This information is used to automatically set an initial
font size for your label. The method used to set this default is intended to help approximate an
optimal starting point for sizing your text.
For continuous printed labels (banners), the default font size is the largest font that prints on the
selected marker width in horizontal orientation.
Changing the Font Size
The maximum font size selectable for a particular label line depends on several factors including label
size, number of characters of text entered on the label line, number of lines of text entered on the
label, rotation, justification, and the font sizes chosen for the label lines.
The printer allows a maximum of 75 characters per line and 23 lines per label. These limits are
dependent on factors such as number and type of characters, font size, and label type.
To set or change a font size:
Step 1. Press
FONT SIZE
The display screen shows the
current font size, bold status,
and auto size status.
Step 2. Use the up/down arrow softkeys, or the
arrows on your keypad to select a font size.
Step 3. Press .
ENTER
Once the font is set for a label line, the size remains the same for any new lines that follow and
remains at the size you choose until you decide to change it.
If you attempt to enter too many characters on a label line, you will receive this error message:
"Cannot Fit." To allow more characters to fit on the line, you must decrease the font size.
16
• Clear Text Only—Select this to clear all text on
your label.
• Clear All—Select this to clear all text and formatting,
including font size. This also applies to all zones in a
multi-zone format.
.
FONT: 10 pt
Bold: OFF
Auto Size: OFF
Handheld Labeler also offers
TM
Handheld Labeler reads the
TM
[▲] [▼]
User Manual