Olivetti SIMPLE_WAY User Manual page 48

Problem
When connecting the printer to
the computer with the USB
cable, the Plug and Play wizard
did not terminate.
When connecting your printer to
the computer with the USB
cable, the New Hardware Wizard
is not displayed on the computer
monitor.
42 CHAPTER 5
Possible Cause
• The computer did not find
the printer driver.
• The computer is running an
incompatible operating
system.
• The USB cable may not be
properly connected between
the printer and computer.
Corrective Action
1 Remove the "Installation"
CD-ROM from the drive and
re-boot the computer.
2 Place the "Installation" CD-
ROM in the drive with the
written label facing upwards.
3 Reinstall the printer software
as instructed in the Setup
Diagram, or as indicated in
the step above.
1 Make sure the computer is
running Windows 98 SE, ME,
2000 or XP, or MAC OS
X 10.2 or later.
1 Turn off your printer and
computer, then unplug the
USB cable from these two
devices.
2 Reattach the USB cable to
the two devices following the
instructions in the Setup
Diagram. Turn on the printer
first, followed by the
computer.