Selecting Navigation; Calling Up The Navigation Main Menu - Becker Traffic Pro 7949 Operating Manual

Selecting navigation

X Press .
2001
Navigation is activated. The display only
appears if navigation has not been acti-
vated since the last time the Traffic Pro
was switched on.
2002
The Fast Access menu then appears. The
number of satellites received appears on
the right-hand side of the display (in the
example, 5 of the maximum of 8 receiv-
able satellites are being received).
In fast access mode, you can select and
navigate to the last destinations entered/
the destinations you have stored in fast
access mode.
For more information, see "Navigation
fast access" on page 32.
Note:
The navigation CD must be loaded
when starting navigation mode for the
first time.
If calibration of the navigation system
has not yet been completed, the system
will prompt you to take a drive for cali-
bration (see Installation Guide).
A navigation CD containing the data for
the target country is required for navi-
gation operations.
The navigation CD must be inserted to
start the calculation of a route. During
calculation, the symbol appears on
the right-hand side of the display. Once
the calculation has been completed, the
symbol disappears, the navigation
CD can be removed and an audio CD
may be inserted.
When entering destinations, driving off
should be delayed until the
has disappeared.
Navigation mode
Calling up the Navigation
main menu
X Press twice.
or
X Press .
The Fast Access menu appears.
X Select the
Old
version
The Navigation menu appears.
X Turn the rotary control/push button
to select one of the following options:
,
or
X Confirm your selection by pressing
the rotary control/push button
symbol
The required function is called up.
entry.
,
.
23