AT&T Four-Line Intercom Speakerphone 974 User Manual page 49

974_CIB_1ATT_033104
i i i i i i i i i i i i
i i i i i i i i
k k
k
i i i i i i i i i i i i
i i i i i i i i
k k
k
44
3/31/2004 5:28 PM Page 44
Make or Answer a Call
continued from page 43
Speakerphone
To make a call, press and release the desired LINE
button or K. The SPEAKER light goes on. Wait
for a dial tone, then dial the call. Press K to end
the call.
To answer a call, press K or press the LINE
button of the incoming call. Press K again to
end the call.
¥
NOTE: If headset is programmed as the default mode
(see "Set Automatic Mode" on page 33), you must
press K to activate the speakerphone.
Headset
You can use this phone hands-free when you install any
industry standard two-band 2.5mm headset (purchased
separately). For best results use an AT&T two-band
2.5mm headset.
Make sure the headset is plugged into the headset jack.
You will hear a double-beep if you press h when
the headset is not plugged in.
¥
NOTE: If headset is programmed as the default mode,
(see "Set Automatic Mode" on page 33) but the
headset is not plugged in, the phone will switch to
speakerphone.
To make a call, press and release h or press
the desired LINE button and then press h. The
HEADSET light goes on. Wait for a dial tone, then dial
the call. Press h to end the call.
To answer a call, press h. Press h
again to end the call.
¥
NOTE: If speakerphone is programmed as the default
mode (See "Set Automatic Mode" on page 33), you
must press h to activate the headset.