AT&T Four-Line Intercom Speakerphone 974 User Manual page 19

974_CIB_1ATT_033104
Table/Desk Installation
continued from page 13
2 Connect the handset cord.
Plug one end of the coiled handset cord into the jack on the left
side of the phone. Plug the other end into the handset and hang up.
3 Connect the power adapter to the telephone.
Plug one end of the power adapter into the jack labeled POWER
on the back of the phone. Plug the other end into a standard
electrical outlet not controlled by a wall switch.
4 Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear a dial
tone, turn to IN CASE OF DIFFICULTY beginning on page 88.
5 Initialization.
If no battery is installed when you connect the power cord,
the phone runs a quick self-test and the screen displays
Initializing.. for about three seconds.
¥
NOTE: The phone will run through this same initialization any time it is
reconnected to AC power if a working battery is not installed (for example,
after a power failure or when the unit has been unplugged).
14
3/31/2004 5:28 PM Page 14
Use only the power adapter provided with this product.
To obtain a replacement, call
POWER jack
1 800 222–3111
.
Standard
Electrical
Outlet
Power adapter