Lucent Technologies PARTNER Advanced Communications System Installation Manual page 52

Installation
4
a. See "Connecting Lines and
Extensions" for instructions for
connecting line and/or
extension jack cords to the new
module.
b. Reconnect the power cord.
!
CAUTION:
The power cord should hang straight down from the connector, flush
against the plastic case for the entire length of the board. Do not install the
power cord at an angle to the case or with a loop in it.
c. Move the On/Off switch to the "On" position ("—").
5
Check that all green lights on the
fronts of the modules are lit:
a. If a single light is out, power
down the control unit, reseat
the module, then power up the
control unit.
b. If multiple lights are out, power
down the control unit, reseat
the leftmost module that has a
light out, then power up the
control unit.
c. If the lights are still out, call for
support as instructed on the
inside front cover of this guide.
6
a. Make sure all modules are
seated properly. The cover will
not fit if the modules are not
seated properly.
b. To replace the cover, grasp it
by its upper edges and hold it
squarely over the control unit.
c. Place the cover over the
modules and make sure it fits
firmly in place.
d. Tighten the screw on the lower
front of the cover.
46
Lights
PFT PFT
L L
I I
N N
E E
S S