Lucent Technologies PARTNER Advanced Communications System Installation Manual page 48

Installation
Replacing Modules in a 5-Slot Carrier
!
!
WARNING:
Before starting, move the On/Off switch to "off" and unplug the power cord.
Verify that you have batteries installed in the PARTNER ACS processor
module, and then disconnect the power cord from the wall jack on the carrier.
1
a. Loosen the screw on the lower
front of the carrier's cover.
Then place one hand on the
handle on the lower front and
the other hand on the top of the
cover.
b. Gently pull the cover up and
away from the carrier. Be
careful not to break the tabs
that attach the cover to the
carrier.
2
Before installing a module, make
sure the clear, plastic protector
has been removed from the
connector area on the rear of the
module. To remove the protector,
grasp the tabs on the ends of the
protector and lift.
3
a. Check the slack in the wires. If
there is not enough slack to
remove the module without
pulling the line and extension
cords free, label and
disconnect the wires before
continuing with Step 3b.
b. Place one hand on top of the
module. With the other hand,
grip the plastic bracket on the
bottom front of the module, and
pull out the old module.
42