Requirements For Fault Management Installation; Certification - Lucent Technologies OneVision DEFINITY G3 Fault Management Installation And Integration Manual

Integration for ibm netview on aix

Hide thumbs Also See for OneVision DEFINITY G3 Fault Management:

Table of Contents

Before You Begin

Requirements for Fault

Management Installation

For Fault Management to be installed and to run properly, your NMS must

be set up with the following:

IBM NetView 4.1

An IBM AIX workstation which meets all hardware requirements

The AIX 4.1 operating system

A 1/4-inch tape drive

20 Mbytes of random access memory

At least 30 Mbytes of free space on the hard drive

Fault Management is designed to run on the AIX operating system. Lucent

Technologies does not explicitly certify any hardware, but does support

Fault Management on any hardware that is certified by IBM.

Issue 1 August 1996

Table of Contents

Need help?

Do you have a question about the OneVision DEFINITY G3 Fault Management and is the answer not in the manual?