AT&T MERLIN LEGEND Release 2.0 Installation Section page 276

Connecting Data Equipment
Analog-to-Digital Modem Option Settings
The following procedure is one method to prepare the 2224G modem for
operation in an analog-to-digital modem pool. This procedure is only a
recommended method and may be different if you are using another type of
modem.
1.
Connect a data terminal such as a PC to the modem (in place of the
data module) and then plug the modem and data terminal into an AC
o u t l e t .
2.
Use the instructions provided with the modem to set switch 1, bit 2 to
the right.
Set all other bit-switches to their default positions.
3.
Save all bit-switch settings by unplugging the modem from the wall
outlet and then plugging it back in.
4.
Set the data terminal speed to match the modem's default speed.
5. Set the default software options:
Type od and press [ENTER] .
6. Set all bit-switches according to Table 6-4, except switch 1, bit 2.
Set switch 1, bit 2 to the right.
7.
Unplug the modem from the wall outlet and then plug it back in.
8. Set switch 1, bit 2 to the left.
This stores the switch settings in the modem's memory.
The modem option settings should now be set as shown in Table 6-4.
6-33
Modem Pools