Installing Telephones And Adjuncts - AT&T MERLIN LEGEND Release 2.0 Installation Section

Installing Telephones and Adjuncts

— When connecting the adjunct to a single-line telephone, do the
following:
— When connecting the adjunct to an analog multiline telephone,
do the following:
c.
— When connecting the adjunct to the 012 module, connect the
adjunct cord directly to the logical ID indicated on the system
form.
3. When connecting adjuncts to telephones, make sure you route the
adjunct and D8W telephone cords through the cord channel.
See Figure 3-7.
4. Test the adjunct by dialing its associated extension.
a. Connect a 267A2 bridging adapter to the telephone.
b. Connect the cord from the adjunct to the bridging
adapter.
c. Reconnect the cord from the control unit to the bridging
adapter.
Connect a 4-pair cord to the OTHER jack on the
a.
telephone.
b. Connect the other end to the VT jack on a general
purpose adapter (GPA).
Connect the cord from the adjunct to the TEL/EQUIP
jack on the GPA.
NOTE:
See the
next section, "General Purpose Adapter
(GPA)," for additional information.
. -
Installing Adjuncts
3-13