DFI LanParty 925X-T2 User Manual page 67

Limit CPUID MaxVal
The CPUID instruction of some newer CPUs will return a value
greater than 3. Problems will occur only in certain operating systems.
The default is Disabled because this problem does not exist in the
Windows series operating systems. If you are using an operating
system other than Windows, this problem may occur. To avoid tihs
problem, enable this field to limit the return value to 3 or lesser than
3.
NX BIOS Control
The default is Enabled. When this function is disabled, it forces the
NX features flag to always return to 0.
3.1.2.2 Hard Disk Boot Priority
This field is used to select the boot sequence of the hard drives.
Move the cursor to this field then press <Enter>. Use the Up or
Down arrow keys to select a device then press <+> to move it up
or <-> to move it down the list.
3.1.2.3 Virus Warning
This field protects the boot sector and partition table of your hard disk
drive. When this field is enabled, the Award BIOS will monitor the boot
sector and partition table of the hard disk drive. If an attempt is made
to write to the boot sector or partition table of the hard disk drive,
the BIOS will halt the system and an error message will appear.
After seeing the error message, if necessary, you will be able to run
an anti-virus program to locate and remove the problem before any
damage is done.
Many disk diagnostic programs which attempt to access the boot
sector table will cause the warning message to appear. If you are
running such a program, we recommend that you first disable this field.
3
BIOS Setup
6 7