DFI LanParty 925X-T2 User Manual page 35

2
Hardware Installation
2.5.2 S/PDIF-in/out Jacks
"
S/PDIF-in
S/PDIF-out
SPDIF in
5
GND
J1
"
SPDIF out
Key
1
+5V
JP8
The system board is equipped with an onboard S/PDIF-in RCA jack
(red) and a S/PDIF-out RCA jack (yellow) at locations CN4 and
CN5 respectively.
The S/PDIF connector at location J1 is used to connect to the
optical S/PDIF-out port that is on the FrontX device. (The FrontX
device, which comes with LANPARTY series products, must be
installed into a drive bay of the chassis.) Refer to the LANPARTY
Features manual for more information about FrontX.
Connect the optical audio cable connector from FrontX to J1. Make
sure pin 1 of the cable connector is aligned with pin 1 of J1. You
may now connect an external audio output device to the S/PDIF
port.
DO NOT use RCA S/PDIF and optical S/PDIF at the same time.
35