Table of Contents
Advertisement
Figure 4
1
status LED
FIGURE 4
LED patterns
Table 1
TABLE 1
LED name
Power Status
(green)
System Status
(bicolor -
amber/green)
Ethernet
Speed (green)
Ethernet
Activity/Link
(green)
Brocade 6510 Hardware Reference Manual
53-1002174-06
shows the LEDs on the non-port side of the switch.
Power supply/fan assembly #2
LEDs on nonport side of Brocade 6510
describes the port side LEDs and their behavior.
Port side LED patterns during normal operation
LED color
No light
Steady green
No light
Steady green
Steady amber (for
more than five
seconds)
Blinking amber
No light
Steady green
No light
Steady green
Blinking green
2
Power supply/fan assembly #1
status LED
Status of hardware
System is off or there is an
internal power supply failure.
System is on and power supplies
are functioning properly.
System is off or there is no
power.
System is on and functioning
properly.
A system fault has occurred.
This LED displays steady amber
during POST, this is normal and
does not indicate a fault.
Attention is required. A number
of variables can cause this
status including a single power
supply failure, a fan failure, or
one or more environmental
ranges has been exceeded.
Port speed is 10 Mbps.
Port speed is 100 Mbps.
There is no link.
There is a link.
There is link activity (traffic).
LED activity interpretation
Recommended action
Verify the system is powered on (power
supply switches to I), the power cables
attached, and your power source is
live.
The unit may be faulty.
Contact your switch service provider.
No action required.
Verify the system is on and has
completed booting.
No action required.
Check the failure indicated on the
system console.
Contact your switch service provider.
Check the management interface and
the error log for details on the cause of
status.
Contact your switch service provider.
No action required.
No action required.
Verify that the Ethernet cable is
connected correctly.
No action required.
No action required.
3
19
Advertisement
Table of Contents
