Change Password; How To Enable Or Disable The Password Function - Barco R9001330 Owner's Manual

Change Password

This item is password protected when the password strap is installed.

How to enable or disable the password function ?

The password function is enabled when the password strap on the
controller module is installed.
To gain acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver or coin
counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly and
lay it down on the second part of the top cover.
5975288 BARCOGRAPHICS 8200 110497
Loosen the locking
screws.
V
B
B
V
D I A G N O S TI C S
C O D E
I R - A C K N O W L E D G E D
R R
RS 232 O UT
I R - R E C E I V E D
Open the top cover
V
B
B
V
D I A G N O S TI C S
C O D E
I R - A C K N O W L E D G E D
R R
RS 232 O UT
I R - R E C E I V E D
Service Mode
Th is de vic e com pli es wi th Pa rt 15 of th e F CC ru les . Op era ti on
is su bje ct to fo llo win g two co nd iti ons :
(1 ) Th is de vi ce m ay no t ca us e h ar mf ul i nte rf er en ce
(2 ) Th is de vi ce m ust a cc ept a ny i nte rf er en ce re ce iv ed
in cl ud in g in te rf er enc e th at ma y ca us e u nd es ir ed op er at io n
I R - R E C E I V E R
1 00 - 23 0 V
9 - 4 A
0 I
6 0 - 50 H z
Th is de vic e com pli es wi th Pa rt 15 of th e F CC ru les . Op era ti on
is su bje ct to fo llo win g two co nd iti ons :
(1 ) Th is de vi ce m ay no t ca us e h ar mf ul i nte rf er en ce
(2 ) Th is de vi ce m ust a cc ept a ny i nte rf er en ce re ce iv ed
in cl ud in g in te rf er enc e th at ma y ca us e u nd es ir ed op er at io n
I R - R E C E I V E R
1 00 - 2 3 0 V
9 - 4 A
0 I
60 - 50 H z
13-7