Barco iD LR-6 R9010342 User Manual page 70

6. Advanced
Important ! In the projectors iD R600 and iD Pro R600 (R9010340 and R9010350) the measuring is done with
white peaking = 0.
In the projectors iD R600+ and iD Pro R600+(R9010341 and R9010351) however, the white peaking must be 10
during the measurement.
The dialogbox shown here are as displayed in the iD R600 and iD Pro R600 (with the field White ).The dialogbox
displayed in the iD R600+ and iD Pro R600+ contain the field White+ instead of White.
The Dynacolor™ Interface
Following parameters are available in the Dyancolor™ Interface:
Measured Values
Red x, y
Green x, y
Blue x, y
White x, y
Red L
Green L
Blue L
White L
Desired Values
Red x, y
Green x, y
Blue x, y
Cyan x, y
Yellow x, y
Magenta x, y
White x, y
Red g
Green g
Blue g
Cyan g
Yellow g
Magenta g
White g
Status
Factory Preset
Basic Dynacolor™ Adjustment
We assume we have a basic setup with 2 projectors, the Dynacolor™ adjustment is done by using only the Dynacolor™ menu:
1. Enable Dynacolor™ on both projectors.
2. Assume the first projector has the following measured values.
66
These are the colors the projector displays when no color changes are made
Coördinates for the Red point
Coördinates for the Green point
Coördinates for the Blue point
Coördinates for the White point
Red Light output
Green Light output
Blue Light output
White Light Output
These are the colors you want the projector to display when the status is enabled
Coördinates for the Red point
Coördinates for the Green point
Coördinates for the Blue point
Coördinates for the Cyan point
Coördinates for the Yellow point
Coördinates for the Magenta point
Coördinates for the White point
Red Light Gain
Green Light Gain
Blue Light Gain
Cyan Light Gain
Yellow Light Gain
Magenta Light Gain
White Light Gain
Enables or disables Dynacolor™
Sets the measured parameters back to the factory preset for the current set
R59770134 ID LR-6 27/05/2011