Barco iD LR-6 R9010342 User Manual page 31

Image 4-2
1 Function keys
2 MENU
3 Address key
4 LOGO key
5
PAUSE
6 STBY
7 MUTE
8
AUTOIMAGE
9 Digit buttons
9b SOURCE button
10 Lens control
11 VOL
12 Picture controls
13 DIGI ZOOM
14 FREEZ
15 PIP
R59770134 ID LR-6 27/05/2011
user programmable keys with functions for direct access.
Menu key, to enter or exit the Toolbar menu.
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
allows to recall the stored Logo (not in PiP mode)
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to go
to standby, press the standby key for 2 seconds.
to interrupt the sound reproduction (audio = optional.
Auto image, to center the image on the active LCD surface.
direct input selection.
this button allows to switch through the active (scanned) inputs
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
use this button to obtain the desired sound level (audio = optional)
use these buttons to obtain the desired picture analog level.
allows a digital Zoom of a part of the image
press to freeze the projected image.
allows to activate the PICTURE IN PICTURE mode
4. Setup
27