Making An Adjustment Via Drag And Drop; Making An Adjustment Via The Floater Menu Or Keyboard - Barco Projector Toolset Reference Manual

13.6 Making an adjustment via drag and drop

How to make the adjustment
1. Click on the selected node and hold down the mouse button.
2. Move the node in the desired direction.
The position of all the other nodes in the active area is recalculated with regard to the new position of
the active node. (image 13-11)
As long as the dots remain green, the warping board can execute this new position. The coordinates
and the status icon of the selected active node are also green;
When the dots become orange, a possible problem can occur on the warping board. The coordinates
values change also to orange and the status icon goes to the error state.
When the dots become red, the warping board is possibly not able to execute these settings. The
coordinates values change also to red and the status icon goes to the warning state.
Image 13-11
A Normal status indication
B Error status indication
C Warning status indication
To solve this problem, go to a higher resolution (more active nodes) and change first
some adjacent nodes before returning to the original node.

13.7 Making an adjustment via the Floater menu or keyboard

About the arrow keys
Click in on the arrow keys of the Floater menu is the same as pressing Ctrl + arrow key on the keyboard.
How to make the adjustment
1. Select the active node to move.
2. Before starting, set first the adjustment step. Click on the drop down box next to Step in the Floating
menu and select the number of pixels one step represents. (image 13-12)
3. Click on the arrow keys to move the node in the desired direction. Each click represents a jump of x
pixels where x is the number set in Step.
R5976924 PROJECTOR TOOLSET 16/04/2009
13. Configurator, Warp User Interface
195