Warp With Commands; Status; Reset; Keystone - Barco Projector Toolset Reference Manual

12. Configurator, Warping

12.3 Warp with commands

12.3.1 Status

Overview
The status of the warping board can be seen next to Warping board.
• On : warping board enabled
• Off : warping board disabled
• Not present : no warping board inserted in the device
• via files : warping is done via a warp file
Image 12-3
How to enable - disable the warping board
1. To enable the warping board, check the check box in front of Enable Warping Board.
When enabled, all other commands become available.
Availability of adjustments
Depending on the first adjusted adjustment, other adjustments are available or disabled.
E.g. when first keystone is adjusted, all other adjustments are disabled.

12.3.2 Reset

Reset values
Click on Reset values to reset the current warp values to its default values.
Reset warping board
The complete warping board is reset. At the same time this board is disabled.

12.3.3 Keystone

What can be done ?
Horizontal and Vertical Keystone adjustment of the image is used to align the image when the device
is mounted at a non standard projection angle. When adjusting a keystone with the warp board, only
pincushion correction is still possible with the warping board. All other adjustments are blanked out.
176 R5976924 PROJECTOR TOOLSET 16/04/2009