Table of Contents
Advertisement
Dual 10
Automatic
T
O MANUALLY SELECT A VIDEO ENCODING MODE
Bring up the OSD main menu.
1
Navigate to the Configuration > Image Sources > (Left/Right)
2
Image Source menu.
Enter the Video Encoding submenu.
3
Select one of the available video encoding modes and confirm.
4
Grayscale conversion modes
A
BOUT GRAYSCALE CONVERSION MODES
Your C
ORONIS
connected video input signals and applies the correct grayscale
conversion settings. Manually selecting a grayscale conversion
mode is possible, but then your display's image source
selection mode should be set to allow this. Please refer to
"Image source selection modes" on page 36 to do this.
Grayscale conversion modes specify how color generated on the display
controller is converted to grayscale in your display.
The available grayscale conversion modes are:
Use Red Channel
Coronis Fusion 10MP
40
Dual 10 is a Barco specific 10-bit video
encoding mode which is usually used on
grayscale displays and which allows full
refresh rate.
When selecting this option, your C
F
10MP display will automatically
USION
assign the correct video encoding settings
to the connected video input signals.
F
10MP display automatically detects the
USION
This mode is intended for grayscale
displays where gray is sent over the red
channel.
ORONIS
:
Advertisement
Table of Contents
