Table of Contents
Advertisement
Page 32
SYMPTOM
Water Coming From Heat Pump
RULE OUT
STEP 2:
Confirm the heat pump mode is set to either "COO" OR
Incorrect mode
"ACH". See "Setting Operating Mode" on page 4 for
setting
more information.
STEP 3:
Incorrect
Confirm the thermostat is set below the ambient air
thermostat
temperature. See "Setting Thermostats" on page 4 for
setting
more information.
STEP 4:
If an external controller is being used, confirm heat
pump is set to accept the controller's signal. See
section entitled "External Controls / Equipment" on
An external
page 22 and "Configuring for External Controller" on
controller is
page 25 for more information.
being used
improperly
If heat pump is set correctly to accept an external
controller's signal, then contact the installer of the
external controller device or the device's
manufacturer for further assistance.
STEP 5:
Error condition
If an error code is displayed, see appropriate fault code
exists
in this section. If no fault code is displayed, proceed to
next step.
STEP 6:
Cooling wrong
Confirm valves are correctly positioned to cool the
body of water
correct body of water.
STEP 7:
Insufficient run
Confirm the water pump is being run long enough to
allow the heat pump to cool the water. See "Heating
time
Water on page 6 for more information.
STEP 8:
Call heat pump installer or AquaCal AutoPilot Customer
Support for further assistance.
STEP 1:
If using chlorine or bromine as a pool/spa sanitizer, use
a test strip in water at heat pump to determine if
sanitizer is present. If sanitizer is present, a leak may
Determine if
exist.
water is from a
leak or
STEP 2:
condensate
Turn off heat pump, leaving water pump on. After
several hours, determine if water is still coming from
heat pump. If water is still coming from heat pump, then
a leak may be present.
STEP 3:
Call heat pump installer or AquaCal AutoPilot Customer
Support for further assistance.
RESOLUTION
Table 11
Advertisement
Table of Contents
