Table of Contents
Advertisement
SECTION 2 - OPERATION
2.1 Control Panel
The following information outlines how the control panel will operate for a standard installation. Control
Buttons will operate differently for custom installations; such as a heat pump connected to an external
controller. Please see appendix section entitled "Connecting External Controllers" for more information.
2.1.a Indicator Lights
"Pool"
"Spa"
"Cooling"
"Desired
Temp"
"Water Temp"
"Heating"
2.1.b Control Buttons
"Pool / Spa"
"Up"
"Down"
"Mode"
2.1.c LED Display
"XXX"
"FLO"
"OFF"
"FS"
"888"
Heat Pump is referencing the pool thermostat.
Heat Pump is referencing the spa thermostat.
Indicates unit is cooling. Please note - both the compressor and the fan must be operating
before this light will illuminate.
Indicates temperature set point is displayed. This is displayed when "UP" or "DOWN" is
selected.
Indicates current water temperature is displayed.
Indicates unit is heating. Please note - both the compressor and the fan must be operating
before this light will illuminate.
Select either the pool or the spa thermostat. (Inactive if unit under external control)
Increase temperature set point.
Decrease temperature set point.
Select heat pump operating mode.
Heat Pump is on and displaying current water temperature.
No water flow is detected. Circulation pump is off or heat pump is not receiving correct water
flow.
Heat pump has been turned off via the mode selector button or the temperature set point has
o
been lowered below 45
F.
Heat pump is in defrosting mode. See section entitled "Heat Pump's Defrost Operation" on
page 7 for more information.
Control program is initializing. Displays only as power is applied to the heat pump. The
program version number will then be displayed.
Page 3
Figure 1
Table 1
Table 2
Table 3
Advertisement
Table of Contents
