Table of Contents
Advertisement
Page 14
4.1.c Access Panels
(Upper Panel)
Evaporator /
Cleaning Access
(Lower Panel)
Compressor
Access
(Lower Panels)
4.2 Placing Heat Pump
4.2.a Indoor versus Outdoor Installation
Outdoor heat pump installations are recommended. Indoor installations require specialized airflow
controls and can be problematic. If no viable alternative exists, contact the AquaCal AutoPilot
Engineering department for assistance prior to proceeding with an indoor installation.
4.2.b Positioning Clearances
Air flow clearances of three (3) feet on each side must be maintained for maximum efficiency of heat
pump. Overhangs must be a minimum of ten (10) feet above equipment.
Keep area immediately adjacent to heat pump clear of shrubs and bushes, lawn furniture,
chemical containers, etc. These items prevent air from circulating fully through heat pump and
result in inefficient and damaging heat pump operation. Proper clearances also provide service
and maintenance personnel access to working parts of the heat pump.
Do not block air from exiting the heat pump by place objects on top of the heat pump. Damage to
the compressor and fan motor will result.
Follow all applicable local, state, and national requirements relative to spacing from other objects
or equipment.
4.2.c Controlling Irrigation and Rainwater Runoff
Avoid placing heat pump in direct rainwater runoff from roofs. If the roof slope directs runoff into the
heat pump, a gutter or rain shield is required on the roof edge above the heat pump. Avoid water
spraying onto the heat pump by re-locating or adjusting irrigation.
Evaporator Coils
Both Sides
Compressor
Access
(Lower Panels)
Condenser
Access Panels
(Below Lower Panel)
Condensation
Connector
(Upper Panel)
Fans / Coil / Capacitor
/ Controller
(Lower Panel)
Electrical Access /
Water Pressure
Switch
Figure 6
Advertisement
Table of Contents
