Table of Contents
Advertisement
STEPS
Enabling Lockout Option
Press and hold "Up" and
"Down" buttons simultaneously
until "CF1" is displayed.
Press "Pool/Spa" button until
"ELC" is displayed.
Press "Up" button once to view
any existing numerical
password.
if desired, press "Up or "Down"
button to change or add a
numerical password
Press "Pool/Spa" Button to lock
in the password.
Press "Pool/Spa" button until
"ULC" is displayed.
Press "Up" button till "1" is
displayed.
Press "Pool/Spa" Button to save
selection.
Wait 15-seconds to allow heat
pump to exit programming
mode.
Unlocking Heat Pump
Press "Up" or "Down" Button.
Press "Up" button to enter the
password.
Press "Pool/Spa" Button.
Disabling Lockout Option
Press and hold "Up" and
"Down" buttons simultaneously
until "CF1" is displayed.
Press "Pool/Spa" button until
"ULC" is displayed
Press "Down" button until "0" is
displayed.
Wait 15-seconds to allow heat
pump to exit programming
mode.
If "LOC" is briefly displayed, followed by a "0", the heat pump is already locked.
A numerical password is required to proceed. See "Unlocking Heat
PumpUnlocking Heat Pump" on page 5 for more information.
Any prior password can be viewed from this program.
The password can be any number from "00" to "99". Without knowledge of the
correct password, control adjustments will not be possible.
Code "0" = User Lock disabled.
Code "1" = User Lock enabled.
The heat pump lock-out feature is now enabled and the heat pump itself is
locked. Any future changes will now require a numerical password.
If the heat pump is locked, "LOC" is briefly displayed followed by a "0",
prompting the entry of the correct password.
If the correct password has been entered, the heat pump is unlocked. The
current water temperature is displayed and control settings are available.
The heat pump locks after being left idle for 15-seconds or after changing a
program option.
Before changing multiple program options it is recommended that the lockout
option be disabled. The lockout option can be re-enabled after all changes
are completed
Code "0" = User Lock disabled.
Code "1" = User Lock enabled.
All programmable features are now available.
EXPLANATION
Page 5
Table 4
Advertisement
Table of Contents
