Replacing The Light Bulb; Maintenance - Euro-Pro 9105 Instruction Manual

MAINTENANCE

Attention: Disconnect the power cord from the wall socket before cleaning the screen and
sewing machine surface, otherwise injury or electrical shock may result.
Cleaning the screen
Cleaning the sewing machine surface
If the surface of the sewing machine is dirty, lightly soak a cloth in neutral detergent, squeeze it
out firmly and then wipe the surface. After cleaning it once in this way, wipe the surface again
with a dry cloth.

REPLACING THE LIGHT BULB

b
a
1
2
If the front panel is dirty, wipe it gently with a
soft, dry cloth.
Do not use any organic solvents or detergents.
Attention: Turn the power switch off and wait
until the lamp has cooled down before touching
it.
1. Loosen the screw (a) on the left side of the
sewing head and remove the face plate (b).
2. Pull light bulb downward to remove.
Replace the bulb with same type rated 5w.
Set the face plate and tighten the screw.
48