Changing The Presser Foot; Replacing The Needle - Euro-Pro 9105 Instruction Manual

CHANGING THE PRESSER FOOT

a
b
1
e
3

REPLACING THE NEEDLE

a
e
c
b
d
2
4
B
A
Attaching the presser foot holder
Raise the presser foot bar (a). Attach
the presser foot holder (b) as illustrated.
Attaching the presser foot
Lower the presser foot holder (b) until
the cut-out (c) is directly above the pin
(d).
Raise the lever (e).
Lower the presser foot holder (b) and
the presser foot (f) will engage
f
automatically.
Removing the presser foot
Raise the presser foot.
Raise the lever (e) and the foot will
disengages.
Attaching the seam guide
Attach the seam guide (g) in the slot as
g
illustrated. Adjust according to need for
hems, pleats, etc.
Attention: Turn power switch to off
("O") when carrying out any of the
above operations!
Change the needle regularly, especially if
it is showing signs of wear and causing
problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle.
The flat side of the shaft should be
towards the back.
B. Insert the needle as far up as it will go.
Attention: Turn power switch to off
("O").
Needles must be in perfect condition.
Problems can occur with:
- Bent needles
- Blunt needles
- Damaged points
7
(1)
(2)
(3)
(4)