Introducing Amanda; Requirements - Amanda @Work.Group/DOS Version 7.xx Installer's Manual

Chapter 1:

Introducing Amanda

Requirements

At a minimum, the PC on which you install Amanda must have:
• MS-DOS version 6.22 in the directory C:\DOS.
• A 486SX processor running at a minimum of 25MHz.
• A VGA card.
• A minimum of 4MB of RAM.
• A minimum of 640K of conventional memory.
• A 3.5-inch, 1.44MB floppy disk drive and appropriate controller.
• An IDE hard disk drive with an access time of less than 14ms and
appropriate IDE controller.
• No LPT2 port (if disabled, it must be non-interfering).
• No devices at addresses 300, 301, 302, 303, 304, or 305.
• No devices using IRQ5 (other than the data modem).
• No devices using IRQ7 (other than the LPT1 port). (This IRQ will
be used by your voice boards.)
• To operate Amanda as Voice Server over a network, you must have
an NE2000 or compatible LAN adapter, configured to use IRQ 10 at
address 340H.
• To operate Amanda as Voice Server with more than one client, you
need a Client Connection Bank (CCB) to activate additional clients.
N : Within the CMOS settings, all adapter ROM shadowing
OTE
should be disabled except for system ROM shadowing at
address F000.