Introducing Amanda; Specification; Environmental Requirements; Electrical Requirements - Amanda @Work.Place Version 3.xx Installer's Manual

Chapter 1:

Introducing Amanda

Specification

Environmental Requirements

Electrical Requirements

The PC on which your Amanda system is installed has:
• MS-DOS version 6.22 in the directory C:\DOS.
• A 386DX processor running at 40MHz.
• A VGA card.
• 4MB of RAM.
• A 3.5-inch, 1.44MB floppy disk drive and appropriate controller.
• A 540MB IDE hard disk drive with an appropriate IDE controller.
• One or two Rhetorex voice boards.
• COM1, using IRQ 4, and COM2, using IRQ 3, which are available for fax mo-
dems or SMDI integration.
• Modem for remote access using the Host/Remote programs.
N : Within the CMOS settings, all adapter ROM shadowing should be dis-
OTE
abled except for system ROM shadowing at address F000. Don't change
the BIOS configuration without consulting an Amanda Company mar-
keting partner or solution provider or an Amanda Company technical
support representative.
• Locate the unit in an area free of excess moisture, dust, corrosive gases, and chem-
icals.
• Install Amanda securely on a table or desk at least 2 feet (.6 meters) above the
floor or mount the system on a wall.
• Use a properly grounded electrical outlet which is not controlled by a switch.
• Ensure that the operating temperature is 40 to 95 degrees Fahrenheit (2 to 35 de-
grees Centigrade), away from direct sunlight.
• Ensure that the humidity is 15% to 90%, noncondensing.
• For proper ventilation and servicing of the unit, provide at least 1 foot (0.3 meters)
clearance on all sides and above the unit.
The electrical requirements are:
• 90 to 130 VAC, 50 to 60 Hz, 3-prong outlet with separate ground, separately fused
at 15 amps.
• Outlet not controlled by an on/off switch.