Logging In To The Web Management Interface - D-Link DWC-1000 User Manual

Logging In to the Web Management Interface

Configuration procedures using the wireless controller's web management interface are
performed using one of the following supported web browsers:
Microsoft Internet Explorer
Mozilla Firefox
Netscape Navigator
Apple Safari
Google Chrome
Before you perform the following procedure:
• Configure your PC running the web browser to use an IP address on the 192.168.10.0
network, with a subnet mask of 255.255.255.0.
• Configure your web browser to accept cookies, prompt for pop-ups, and allow sites to run
JavaScript.
• Upgrade the firmware for your wireless controller (see "Upgrading Firmware" on page
205).
• Upgrade the firmware for your access points after you upgrade the wireless controller
firmware (refer to the documentation for your access points). Firmware can be
downloaded from:
– http://dlink.com/support/Wireless/dwl3600ap/Firmware/
– http://dlink.com/support/Wireless/dwl6600ap/Firmware/
– http://dlink.com/support/Wireless/dwl8600ap/Firmware/
To log in to the web management interface:
1. Launch a web browser on the PC.
2. In the address field of your web browser, type the IP address for the wireless controller
web management interface. Its default IP address is http://192.168.10.1. A login prompt
appears. If the login prompt does not appear, see "Troubleshooting the Web Management
Interface" on page 213.
Basic Configuration
Browser
DWC-1000 Wireless Controller User's Guide
6.0 or higher
3.5 or higher
9.0 or higher
4.0
5.0
27
Version