D-Link DWC-1000 User Manual page 224

The following table describes the options on this page.
Option
Remote Log Identifier
Enable E-Mail Logs
E-Mail Server Address
SMTP Port
Return E-Mail Address
Send to E-mail Address(1) (2) (3)
Authentication with SMTP Server
User Name
Password
Respond to Identd from SMTP
Server
To receive e-mail logs according to a schedule, configure the appropriate schedule settings. Scheduling options are enabled when the
Enable E-Mail Logs option is checked.
Troubleshooting
Log Options
Enter a prefix used to identify the source of the message. This identifier is prefixed to both e-mail
and Syslog messages.
Routing Logs
Enables or disables email logs. Choices are:
Checked = enable email logs. Complete the remaining fields on this page.
•
Unchecked = disable email logs. The remaining fields on this page are unavailable.
•
If Enable E-Mail Logs is checked, enter the IP address or Internet Name of a Simple Mail
Transfer Protocol (SMTP) server. The wireless controller will connect to this server to send e-mail
logs when required. The SMTP server must be operational for email notifications to be received.
If Enable E-Mail Logs is checked, enter the SMTP port of the e-mail server.
If Enable E-Mail Logs is checked, enter the e-mail address where replies from the SMTP server
are to be sent (required for failure messages).
If Enable E-Mail Logs is checked, enter up to three email addresses where logs and alerts are to
be sent.
If Enable E-Mail Logs is checked, select an authentication if the SMTP server requires
authentication before accepting connections. Choices are:
None = no authentication is used. The User Name and Password fields are not available.
•
Login Plain = authentication used to log in using Base64-encoded passwords over non-
•
encrypted communication session. Base64-encoded passwords offer no cryptographic
protection, making them vulnerable.
CRAM-MD5 = a challenge-response authentication mechanism defined in RFC 2195 based on
•
the HMAC-MD5 MAC algorithm. CRAM-MD5 offers a higher level of authentication than Login
Plain.
If Authentication with SMTP Server is set to Login Plain or CRAM-MD5, enter the user name to
be used for authentication.
If Authentication with SMTP Server is set to Login Plain or CRAM-MD5, enter the case-sensitive
password to be used for authentication.
If Enable E-Mail Logs is checked, this option determines whether the wireless controller responds
to IDENT requests from the SMTP server. Choices are:
Checked = wireless controller responds to an IDENT request from the SMTP server.
•
Unchecked = wireless controller ignores IDENT requests from the SMTP server.
•
Send E-Mail Logs by Schedule
224
DWC-1000 Wireless Controller User's Guide
Description