D-Link DWC-1000 User Manual page 131

Table 7-2. Fields on the WIRELESS LAN AP INFORMATION Page
Field
MAC Address (*) Peer Managed
IP Address
Age
Status
Profile
Radio Interface
Table 7-3. Buttons on the WIRELESS LAN AP INFORMATION Page
Button
View AP Details
View Radio Details
View Neighbor APs
View Neighbor Clients
View VAP Details
View Distributed Tunnelling Details
Viewing Status and Statistics
Ethernet address of the managed access point. If an asterisk (*) follows the MAC address, the
access point is managed by a peer controller.
Network IP address of the managed access point.
Time since last communication occurred between the wireless controller and the access point.
Current managed state of the access point. Possible values are:
Discovered = access point is discovered by the wireless controller, but not authenticated.
•
Authenticated = access point has been validated and authenticated (if authentication is
•
enabled), but it is not configured.
Managed = profile configuration has been applied to the access point and the access point is
•
operating in managed mode.
Failed = wireless controller lost contact with the access point. A failed entry remains in the
•
Managed AP database, unless you remove it. Note that a managed access point shows a
failed status temporarily during a reset.
If management connectivity is lost for a managed access point, both of its radios are turned down
and all clients associated with the access point are disassociated. The radios resume operation
when that access point is managed again by a wireless controller.
Configuration profile applied to the managed access point. The profile is assigned to the access
point in the Valid AP database.
Wireless radio mode that each radio on the access point is using.
Shows detailed status information collected from the access point.
Shows detailed status for a radio interface.
Shows the neighbor APs that the specified AP has discovered through periodic RF scans on the
selected radio interface.
Shows information about wireless clients associated with an access point or detected by the
access point radio.
Shows summary information about the virtual access points (VAPs) for the selected access point
and the access point radio interface that the wireless controller manages.
Shows information about the L2 tunnels currently in use on the access point.
131
DWC-1000 Wireless Controller User's Guide
Description
Description