Led Troubleshooting; Power Led Is Off; Lan Port Leds Not On - D-Link DWC-1000 User Manual

LED Troubleshooting

After you apply power and turn on the wireless controller, the following sequence of events
should occur:
1. When power is first applied, verify that the front panel (green) Power LED to the left of the
USB ports is ON.
2. After approximately 2 minutes, verify that the right LAN port LED is ON for any local ports
that are connected. This indicates that a link has been established to the connected
device.
3. If a port is connected to a 1000 Mbps device, verify that the port's right LED is orange. If a
port is connected to a 100 Mbps device, verify that the port's right LED is green. If a port is
connected to a 10 Mbps device, verify that the port's right LED is OFF.
If any of these conditions do not occur, see the appropriate section below.

Power LED is OFF

If the Power and other LEDs are off when your wireless controller is turned on, confirm that
the power cord is connected properly to the wireless controller and that the power cord is
connected to a functioning power outlet that is not controlled by a wall switch.
If the error persists, please contact D-Link technical support.

LAN Port LEDs Not ON

If the LAN LEDs do not go ON when the Ethernet connection is made:
1. Check that the Ethernet cable connections are secure at the wireless controller and at the
switch.
2. Be sure power is applied to the connected switch and that the switch is turned on.
3. Be sure you are using the correct cables (straight-through or crossover).
Troubleshooting
212
DWC-1000 Wireless Controller User's Guide