Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual page 16

Figure 3
a
b
Step 7 Place the removed RSP2 on an antistatic mat or foam. If you plan to return the RSP2 to the factory,
immediately place it in an antistatic bag to prevent ESD damage.
Step 8 Attach the equipment end of the ESD-preventive strap to the RSP2 before performing any maintenance
on the RSP2 that might create an ESD hazard.
This completes the removal procedure. If you removed the RSP2 to replace SIMMs, proceed to the
"Software Configuration Register Settings" section on page
to the next section to install the new RSP2.
16
Ejector Levers and Captive Installation Screw
Processor
module
carrier guide
Captive
installation
screw
STOP!
on contact
Bottom ejector lever
Processor module
slot
c
79. If you are replacing the RSP2, proceed
OL-4923-01 B0