Reference Information - Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual

change boot characteristics? y/n [n]
enabled are:
console baud: 9600
boot: image specified by the boot system command
do you wish to change the configuration? y/n [n]
You must reset or power cycle for the new config to take effect
Initialize the router by entering the i command as follows:
Step 7
rommon 1 > i
The router power cycles, the configuration register is set to ignore the configuration file, and the router
boots the boot system image and prompts you with the system configuration dialog as follows:
Enter no in response to the system configuration dialog prompts until the following system message is
Step 8
displayed:
Press RETURN to get started!
Press Return. After some interface information, the prompt appears as follows:
Step 9
Router >
Enter the enable command to enter the enabled mode. The prompt changes to the following:
Step 10
Router #
Enter the show configuration EXEC command to display the enable password in the configuration file.
Step 11
Enter the configure terminal command at the EXEC prompt. You are prompted as follows:
Step 12
Router# configure terminal
Enter configuration commands, one per line.
Router(config)#
Using the config-register 0xvalue command, change the configuration register value back to its original
Step 13
value (noted in
Exit the configuration mode by entering Ctrl-Z.
Step 14
Reboot the router and enable it using the recovered password.
Step 15
This completes the procedure for recovering a lost password.

Reference Information

The following sections include important reference information:
•
•
•
•
76
Configuration Summary
or default to: cisco2-RSP
--- System Configuration Dialog ---
Step 3) or change it to a value of 0x0102 (factory default).
Console Port Signals, page 77
Auxiliary Port Signals, page 77
Console and Auxiliary Y-Cable Pinouts, page 78
Software Configuration Register Settings, page 79
End with CNTL/Z.
OL-4923-01 B0