Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual page 46

exec-timeout 0 0
history size 40
transport preferred none
transport input none
line aux 0
line vty 0 4
login
Configuring a Stateful Switchover (SSO)
Each task in the list is identified as either required or optional.
•
•
•
To configure SSO, use the following commands beginning in privileged EXEC mode:
Command
Step 1
Router# configure terminal
Step 2
Router(config)# hw-module slot slot-number image
file-spec
46
Configuring a Stateful Switchover (SSO), page 46
Configuring Frame Relay Autosynchronization LMI Sequence Numbers, page 47
Verifying SSO, page 47 (optional)
(required)
Purpose
Enters configuration mode.
Specifies the image to be used by the active RSP at
initialization. If a high-availability image is found,
the running configuration is updated.
• slot-number—Specifies the active RSP slot
where the Flash memory card is located. Valid
numbers are slot 2 or slot 3 for a Cisco 7507
router or slot 6 or slot 7 for a Cisco 7513
router.
file-spec—Indicates the Flash device and the
•
name of the image on the active RSP.
Note: Step 2 and Step 3 are the same; Step 2
applies to the active RSP and Step 3 applies to
the standby RSP.
Note The image indicated by the file-spec
attribute must be available on the local Flash
device. Remote protocols such a TFTP and remote
copy are not available.
(optional)
OL-4923-01 B0