Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual page 21

Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Mon 22-Jan-96 21:15 by biff
Image text-base: 0x600108A0, data-base: 0x607B8000
cisco RSP2 (R4600) processor with 16384K bytes of memory.
R4600 processor, Implementation 32, Revision 2.0
[additional displayed text omitted from this example]
8192K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Slave in slot 3 is halted.
[additional displayed text omitted from this example]
With a single RSP2 (non-HSA or non-HA), verify that the console terminal displays the system banner
Step 4
and startup screen as the system restarts. The display should look similar to the following:
System Bootstrap, Version 11.1(2) [biff 51096], RELEASED SOFTWARE
Copyright (c) 1994-1996 by cisco Systems, Inc.
SLOT 6 RSP2 is system master
RSP2 processor with 16384 Kbytes of main memory
[additional displayed text omitted from this example]
Cisco Internetwork Operating System Software
IOS (tm) GS Software (RSP-JV), Version 11.1(4) [biff 51096]
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Mon 22-Jan-96 21:15 by biff
Image text-base: 0x600108A0, data-base: 0x607B8000
cisco RSP2 (R4600) processor with 16384K bytes of memory.
R4600 processor, Implementation 32, Revision 2.0
[additional displayed text omitted from this example]
After the system boots the software and initializes the interface processors, verify that the RSP2 LEDs
Step 5
are in the following states:
RSP2 normal LED is on (for each RSP2 installed).
•
CPU halt LED is off (for each RSP2 installed).
•
Active RSP2 active LED is on (if HSA or HA is configured).
•
Standby RSP2 standby LED is on (if HSA or HA is configured).
•
Step 6 Verify that all the enabled LEDs (on the interface processors) are on.
Step 7 In systems with a second RSP2 installed (and HSA or HA configured), use the show version command
to verify that the standby RSP2 is recognized by the system. Following is a sample from a Cisco 7513:
Router> show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (RSP-JV), Version 11.1(4) [biff 51096]
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Mon 22-Jan-96 21:15 by biff
Image text-base: 0x600108A0, data-base: 0x607B8000
[additional displayed text omitted from this example]
Slave in slot 7 is running Cisco Internetwork Operating System Software
(Note that this could also be "slot 6" depending on which RSP2 is configured as the slave or the recent
crash history of your router.)
OL-4923-01 B0
21