Step 1; Copying An Image Onto An Rsp - Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual

Copying an Image onto an RSP

Use TFTP to copy a high availability Cisco IOS image onto the active and standby RSPs:
Command

Step 1

Router# copy tftp slot slot-number :
Address or name of remote host []? ip-address
Name of file to copy []? imagename <Return>
writing filename!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Destination filename? [ imagename1 ] <Return>
Accessing tftp:// host ip-address /file 'imagename' on
ip-address.. found !
11188128 bytes copied in 2280.664 secs (4906
bytes/sec)
Step 2
Router# copy tftp slaveslot slot-number :
Address or name of remote host []? ip-address
Name of file to copy []? imagename <Return>
writing
filename!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Destination filename? [ imagename1 ] <Return>
Accessing file 'imagename' on ip-address.. found !
903500 bytes available for writing without erasure.
Loading imagename from ip-address (via Ethernet1/0):
!
[OK - 3320245/4194176 bytes]
1. Before you copy a file to Flash memory, be sure there is ample space available in Flash memory. Compare the size of the file you are copying to the
amount of available Flash memory shown. If the space available is less than the space required by the file you will copy, the copy process will continue,
but the entire file will not be copied into Flash memory.
42
Purpose
Uses TFTP to copy a high availability Cisco IOS
image onto the Flash memory card of the active RSP.
slotslot-number—Specifies the Flash memory
•
card of the active RSP.
The router prompts you for the IP address of the
TFTP server.
ip-address—Specifies the IP address of the TFTP
•
server that contains the new image.
The router prompts you for the name of the image file
you are copying to the Flash memory card.
• imagename—Indicates the name of the image to
be loaded onto the Flash memory card.
The router prompts you to enter the name under
which you want the file to appear at the destination.
imagename1—Indicates the name of the image
•
as it appears at the destination.
Uses TFTP to copy a high availability Cisco IOS
image onto the Flash memory card of the standby
RSP.
slaveslotslot-number—Specifies the Flash
•
memory card of the standby RSP.
The router prompts you for the IP address of the
TFTP server.
ip-address—Specifies the IP address of the TFTP
•
server that contains the new image.
The router prompts you for the name of the image file
you are copying to the Flash memory card.
• imagename—Indicates the name of the image to
be loaded onto the Flash memory card.
The router prompts you to enter the name under
which you want the file to appear at the destination.
• imagename1—Indicates the name of the image
as it appears at the destination.
1
OL-4923-01 B0