Table of Contents
Advertisement
Failover Probe
Cycle
Failback Probe
Cycle
Detect Rule
If 3G is set for main port, then there can be no option for
failover/failback.
The time set is for each probe cycle, but the decision to change to the
backup port is determined by Probe Cycle duration multiplied by
Connection Decision amount (e.g. From the image above it will be
12 seconds multiplied by 5 consecutive fails).
The time set is for each probe cycle, but the decision to change to the
backup port is determined by Probe Cycle duration multiplied by
Connection Decision amount (e.g. From the image above it will be
3 seconds multiplied by 5 consecutive fails).
Set the time duration for the Failover Probe Cycle to
determine when the router will switch to the backup connection
(backup port) once the main connection (main port) fails.
Set the time duration for the Failback Probe Cycle to
determine when the router will switch back to the main
connection (main port) from the backup connection (backup
port) once the main connection is communicating again.
Select the detection rules for the failover of the main interface.
•
Rule 1. ADSL Down
•
Rule 2. Ping Fail
No Ping: It will not send any ping
packet to determine the connection. It
means to disable the ping fail detection.
Ping Gateway: It will send ping packet
to gateway and wait response from
gateway in every "Probe Cycle".
Ping Host: It will send ping packet to
specific host and wait response in every
"Probe Cycle". The host must be an IP
address.
61
Advertisement
Table of Contents
